The M1C and M1D Garand Sniper Rifles

By Tom Laemlein
Posted in #Guns #History
Save
Save Remove from saved articles
Like
Like Unlike
Share
Facebook Share Twitter Share Pinterest Share

The M1C and M1D Garand Sniper Rifles

March 2nd, 2021

7 minute read

It’s difficult to imagine now, but as America entered World War II in December 1941, the U.S. military had no appreciable sniper program and no designated sniper rifle.

The semi-automatic M1 Rifle, adopted in 1936, was still being developed as a sniper rifle. In the meantime, U.S. Ordnance turned to the simplified M1903A3 rifle, adopted in 1943, to create the straightforward sniper rifle designated the M1903A4.

M1903A4 – Problems and Imperfections

The M1903A4 is not an exceptional rifle by any means and was considered a disappointment as a sniping weapon by many. The commercial Weaver telescopic sight proved too fragile and prone to fogging in humid environments.

Springfield M1903A4 sniper rifle in World War II
The U.S. military began World War II without an official sniping rifle. By the end of the war, the M1903A4 was essentially the U.S. standard. Image: NARA

Perhaps a larger problem was the M1903A4 rifle was no more accurate than a standard M1903A3 battle rifle.

Most of the approximately 28,000 made during World War II went to the U.S. Army, but there were some that went to the Marine Corps. Even though the M1903A4 was a plain-Jane sniper rifle, they did enough good work to stay in U.S. service until the Korean War.

Beginnings of the M1 Sniper Rifles

In its earliest days, the M1 Rifle was troublesome to the old guard of Army NCOs. The old salts assumed that, when compared to the bolt-action M1903 Springfield rifle, the M1 was inaccurate and its semi-auto action would lead our soldiers to waste ammunition.

M1 Garand sniper rifle
Even without a telescopic sight, the M1 delivered excellent performance out to 500 yards. This soldier takes aim at German targets in November 1944. Image: NARA

Some of these notions persisted until the M1 rifle finally entered combat in December 1941. The Garand rifles were found to be accurate, robust, and reliable, capable of delivering a high volume of fire in any combat environment.

Traditional American marksmanship meant the standard M1 rifle was often good enough to be used as a sniping weapon within the limits of human eyesight.

Back in the states, work progressed slowly on developing the M1 into a true sniping rifle equipped with a telescopic sight. But, there were obstacles to overcome.

US soldier shooting an M1 Garand sniper rifle
The Garand proved to be a very capable shooter. Here is one in action in Germany during the fighting in March 1945. Image: NARA

The M1’s top-loading and top-ejecting action was a significant challenge. Unable to mount the scope directly over the receiver, experiments were made with a prismatic scope that featured an offset tube. When this proved fruitless, U.S. Ordnance determined that the scope should be mounted on the left of the receiver — allowing normal operation of the M1 rifle.

Enter the M1C

Following a series of tests, a commercial telescopic sight base and mount built by Griffin & Howe (at that time owned by Abercrombie & Fitch) was chosen for the new M1 sniping variant.

M1C sniper rifle in WWII
The M1C in combat during World War II. Very few of these rifles made it into action during that conflict. Image: NARA

The strongly-constructed G&H base was attached to the M1 receiver with little modification — just three screws and two taper pins held the scope mount in place. The whole arrangement was sturdy and could easily be removed while maintaining the “zero” of the scope.

U.S. Ordnance chose the Lyman “Alaskan” telescope for the rifle, and the scope was later standardized in two versions: the M81 featuring a cross-hair reticle and the M82 using a tapered-post reticle.

During June 1944, the new rifle (designated M1E7) was adopted and standardized as the M1C. Consequently, the M1903A4 sniper rifle became “limited standard”.

However, production of the M1C did not begin in earnest at Springfield Armory until later that year, and the new sniper rifles only reached the troops in small amounts, and less than 8,000 were constructed before the end of the war.

US sniper with M1C rifle in WWII
Wartime color image of the M1C sniper rifle taken in the ETO during the late spring of 1945. Image: NARA

So far as is known, no M1C rifles were used in combat in Europe. I have included a pair of war-time color images in this article that show the M1C in Italy during 1945 — but these were likely taken after the war had ended. I have never found an image of an M1C in combat during World War II.  

In his book Ordnance Went Up Front, World War II ordnance man Roy Dunlap briefly described the M1C:

They were beautiful outfits and I would have given anything to have had one during the war, but they arrived in the Philippines just before the Japanese surrendered. The rifles were selected, the best finished and tightest M1s I ever saw, and of course sights and rifle came together as a unit.

Ordnance Went Up Front

The M1C was equipped with the M2 flash hider and a leather cheek pad treated for mildew resistance (made by Kay Leather Company).

The Alaskan scope (M81/M82) was configured for “all-weather” use, with moisture-proof adjustment screw caps and critical internal parts.

The effective range of the M1C seems to be a matter of opinion, but 800 yards seems to be the agreed-upon practical limit. Of course, some exceptional marksmen scored kills at higher ranges.

M1C Sniper Rifle in the Korean War held by soldier
A M1C sniper rifle held by a U.S. soldier of the 1st Cavalry Division in Korea during September 1950. Image: NARA

The M1C in the Korean War

The M1C saw the lion’s share of its combat duty during the Korean War (1950-1953).

Marine Staff Sergeant John E. Boitnott achieved a measure of national celebrity using the M1C in the counter-sniper role during his service with the 5th Marine Regiment at Outpost Yoke. While his observer/spotter PFC Henry Friday moved about in clear view of enemy snipers to draw their fire and expose their positions, Boitnott recorded nine confirmed kills over two days with his scoped Garand rifle.

During the Korean War, the majority of reports about the M1C were favorable, but as far as its use in the U.S. Army was concerned, there was little excitement about the M1C. Part of the reason for the indifferent attitude towards the M1 sniper rifle was the overall lack of a “sniper culture” in the Army.

U.S. Marine sniper with M1C in Korean War
A U.S. Marine sniper shooting an M1C rifle in Korea during September 1950. Image: NARA

After World War II, the Marine Corps continued its scout-sniper program, with the snipers using a mix of M1903A1/Unertl, M1903A4, and M1C rifles. During the Korean War, the Marine Corps made some modifications to the M1C, particularly its telescopic sight.

Firearms researcher Bruce Canfield, an expert on the M1 rifle describes the USMC variant of the M1C, and the confusion about its proper designation:

The M1C was issued with the M81 and M82 scopes which had some deficiencies, especially the power. The Marine Corps tested several types of telescopes and settled on a 4x design to be supplied by Kollmorgen. A larger and somewhat different Griffin & Howe mount was also chosen by the Marines for their ‘new’ sniper rifles. The ‘new’ Marine Corps sniper rifle was given the designation ‘USMC 1952’ which was sometimes referred termed ‘MC 52’. The designation ‘MC-1’ referred only to the scope and mount, and not the entire rifle. Thus, reference to a ‘MC-1’ rifle is incorrect.

Bruce Canfield

End of the Line: The M1D

Just a few months after the M1C was adopted, the M1D was adopted as substitute standard in September 1944. While it may seem strange to develop separate, specialized sniping versions of the same rifle, the explanation is quite practical.

Sniper with M1D rifle in South Vietnam War
ARVN scout-sniper training with the M1D during 1969. Image: NARA

The M1D was adopted as a substitute for the M1C, creating an easier-to-produce fallback option in case production facilities were unavailable to build the required amount of M1C rifles.

The M1D project also resulted in the development of improved telescopic sights, culminating in the standardization of the 2.2X M84 scope, equipped with sealed optics, protective metal covers on the elevation/windage adjustment knobs, and a sliding light shade. The M1D’s scope could also be mounted without removing the rifle’s iron sights.

By comparison, the M1D was easily created by modifying standard M1 rifles, the conversion process requiring little more than replacing the standard barrel with the special M1D barrel which featured an integral mounting block.

South Vietnam soldier with Springfield M1D rifle
A U.S. Marine works with a South Vietnamese Popular Force recruit and his M1D rifle. Image: NARA

Even though the M1D was ultimately superior to the M1C, the timing of its production effectively kept it from seeing extensive combat. The M1D did not see service in World War II, and when it was put into full-scale production during the Korean War, that conflict was over before the M1Ds could fire shots in anger against the Communist Koreans and Chinese.

Small numbers of the M1D did serve with American troops in combat, with action in Lebanon during 1958, the Dominican Republic in 1965, and in the early days of America’s involvement in the Vietnam War.

USMC training ARVN soldier with M1D sniper rifle
A USMC instructor shows an ARVN soldier how to operate the M1D rifle at the Dai La Pass range in November 1969. Image: NARA

Over time, the U.S. Army paid more attention to sniping and finally, in 1987, the Army’s Sniper School was established at Fort Benning. There were still a handful of M1D rifles in service even then, particularly with Army Reserve and National Guard units.

Editor’s Note: Please be sure to check out The Armory Life Forum, where you can comment about our daily articles, as well as just talk guns and gear. Click the “Go To Forum Thread” link below to jump in and discuss this article and much more!

Join the Discussion

Go to forum thread

Continue Reading
Did you enjoy this article?

Springfield Armory® recommends you seek qualified and competent training from a certified instructor prior to handling any firearm and be sure to read your owner’s manual. These articles and videos are considered to be suggestions and not recommendations from Springfield Armory. The views and opinions expressed on this website are those of the authors and do not necessarily reflect the views and opinions of Springfield Armory.

Product prices mentioned in articles and videos are current as of the date of publication.

Tom Laemlein

Tom Laemlein

Tom Laemlein is a historian. While that might sound mind-numbingly awful to some, he enjoys it. His deep dives into historical research keep him (mostly) out of trouble and, yet, too often away from the rifle range. Tom is the author of more than 30 books on military history and weapons systems. He regularly contributes articles to national magazines and websites on military history and firearms topics, and historical photos from his collection are used by publishers around the world. In those times that he is cornered in a corporate environment, he will talk about marketing until he is released. Tom is married to a very patient woman, and they live on America’s North Coast, near Lake Ontario. His regular misadventures with Wally, his young Tibetan Mastiff, remind him that life must be enjoyed full-bore, at least until you are ready for a nap.

© 2024 Springfield Armory. All rights reserved.

Springfield Armory
Login

No account? Create One

Create Account

Have an account?