Recent content by edr9x23Super

Looking at your 1911 targets, I would say going to a gunsmith (a good one that specializes in 1911s) and just having a good trigger job done on that gun will tighten those groups up sufficiently. I would say with a good, 4lb trigger you could cut those group sizes in half. You can also check...

No worries, you did just fine. SA “entry level” 1911s are light years beyond where 1911s were when I got into competition shooting in the late 1980s. I took my Ronin straight out to the range after I picked it up and the LGS and found that the gun punched way above it’s weight in terms of barrel...

The difference? That's an easy to answer question. regardless of model, price or even brand, the difference is who is behind the gun operating it. All the money, name and bells and whistles cannot make a mediocre shooter a Master, In 1989, I earned my "M" card in USPSA shooting a Springfield...

Bought this Ronin I think 3 years ago, this gun punches way above its weight. Pictured first is what it looked like when I purchased it. Since, I had the sharp edges knocked off, a mag well installed and then hard chromed to finish and some Herretts grips. Hard chroming and edge smoothing was...