Recent content by everSearching

Thanks everyone for lending your ideas.

Ha!

I didn’t even know about hard primers. I got into this hobby/sport a few years ago so I’m most definitely still learning. Thanks for educating.

Went to the range today and fired the gun in question. Ran flawlessly. But when I go to clean it I’ll check it out. Thank you helping.

I’m a bit of a slippery fellow so too much lube could be an issue I’m creating for myself. I’ll look at the pistol and see if it’s a bit too wet. Thanks.

You hear so many people talking about their EDC and the faith they would lose if there was a single malfunction. Guess I bought into it. Thank you for taking time to respond…

Thank you.

I didn’t even think of that. Should have. I fed the round again and got the desired outcome, noise and vibration. Thank you for your thoughts.

It was Blazer Brass. I clean my guns every time I use them. Thank you for weighing in.

I’ve got about 600 rounds through my EDC, a Canick Mete MC9. While shooting one day I had a light strike. That was the one and only issue with this gun. Should I wonder about the reliability. I thought I’d run it to 1000 and if I have another issue with the pistol then I switch to something...

Is there any scuttlebutt on the arrival of more Hellcat Pro’s with a thumb safety?

I like the looks of that EMP. Especially the one with the silver frame and dark slide. To be honest, I’m not sure I knew these existed. Thanks for your thoughts.

I might give that a try. I’ve got digital calipers somewhere so I can determine the height and diameter of the current screws. Thank you.

It amazes me that some of the optics cost more than the gun. It’s kinda nuts. Oh, and by the way, I’ve had to remove many splinters from my rear end because of poor life choices.

Springfield makes a good firearm. My only issue with the Prodigy is that the optic keeps coming loose because there is so little room between the slide and the extractor that you must use very short screws as slightly longer screws will hamper the extractor and the gun won’t cycle. I’m going...