Search results

Also took the little poverty pony with a can, now i find a lot of times rifles are not as accurate with a can, this one is one of them. 5.56 don't silence anyway.

Went across the road to shoot, this little rossie is kinda fun to shoot super quiet with the can. ran 100 rounds through it and not one malfunction. was pretty accurate until the top rail came loose. i always check those and put loctite on them before use. i forgot to check it this time. my fault.

You got a pic of the first ford that came off the showroom floor you bought

Tryin to decide what i want to do, think i may go across the street and shoot and then clean up the guns then go clear me a path out to the next tree to cut up.

You ole romantic rascal you.

I like it when they are tight, usually means no slack between halves. i just use a punch and small hammer to tap them through a bit. never a need to remove them. i shoot and clean a lot of AR's and built a cleaning stand which works perfect. Easy to change between 308 and 5.56 platforms. and it...

1000 rounds 115 grain magtech 9mm, 500 rounds of 147 grain sub sonic magtech 9mm.

So much for putting him in a cell with bubba for the rest of his life, he's probably enjoy what bubba does.

So the dude was a turd burglar after all.

How does that 25 round mag run? I just bought a rs22 pistol. 10 rounds is like...well you know.

Rossi version of the charger.

These poverty ponies are dirt cheap now around here. This one has zero slop between halves. Gas block is tight too

Yes it is, i had some target pics where i shot it, guess i deleted them

Huh! yer in Texas right? that sounds like something one of them commie states would do.

Not one Hy point in the bunch. :mad:

Went chootin, took the bear creek upper on the poverty pony lower and shot twice. both times the cartridge hung up and i had a heckuve time gettin it out. so took over to house and hit the chamber with wire brush and took back and same thing. so i went to the gun shop to see if he could polish...

Hopefully he shattered his ankle.

Now they need to make an example out of him.

Your screw is either an m3x8 or an m3x12 I showed two or three pictures the 8 to 12 and the 16 if anything if you get an M3 by 12 or 16 and it's too long you can always cut it down to make it fit the m3x8 will probably work I'm not 100% sure how long it has to be to go through your site but it...

Nor dead, got one on me hip right now.