I would try basic stuff first before I made significant changes.
Since the OP doesn't indicate what you dislike about the trigger, I'm going to figure you want to lighten the pull a bit and smooth it out.
In my experience, Glock OEM triggers are inconsistent with regard to break. Some break pretty clean while others mush through it (more common). Change here will require changing parts.
Start with a couple of basic things. Strip the slide and clean the internal channels. Even if the gun is new, there's always a possibility of some residue inside. Spotless and dry are what you are looking for.
While you have it apart, check to see if the channel liner is rough. You can move the striker assembly in it and determine how it feels. It should move smoothly and freely. I suspect Gen 6 still has a replaceable liner, but don't have firsthand knowledge.
On the frame, polish the trigger bar where it contacts the connector and the side that runs along the frame. Polish the top of the nub that contacts the safety plunger. Polish, don't remove material!
Install a minus connector that has been polished. Use a bit of polishing material to smooth the frame side next to trigger bar. Polish the safety plunger face that contacts the trigger bar and the sides of the plunger.
Basic parts you can swap that may help smooth things out:
1) Trigger connector
2) Reduced power safety plunger spring
3) Channel liner (stainless v. plastic)
Clean everything well and reassemble it. Glock says to put a drop of oil where the trigger bar and connector interface. I generally put a drop on before I put things back together.
These are things I am comfortable doing on a carry gun. The trigger isn't going to be on par with an OEM Canik, even if you go the GPT route. You can get them better, but a good Glock trigger comes from the aftermarket.