Recent content by Tgunz64

It feels good. Not to big or too small. Fits tight. Install was pretty easy. If you have the right wrench, vise block and vise. If you have all the tools ready it’s about a 10 minute or so job.

One more

Here’s a few

I can. Sorry after my last post I haven’t been on until now. I’ll try and get a few on here.

Got the Handguard mounted. Looks good and went on just fine. Plenty of room for the Sandman can to do its job!

Yes they do. This one has plenty of id room

Larger than 1.55”

Yes. That’s why I went with this model. I could only find two models with inside diameters large enough for a suppressor. This one and one from Aero. Maybe there’s more but I didn’t find them.

I think it does come with it.

Thank you! This is the answer I’ve been looking for. And yes I have removed Handguards before and have all the tools to do it.

Like to put a new Handguard on my saint pistol to accommodate a suppressor. I saw saints are mil spec so I ordered the Midwest Ind. suppressor ready Handguard. But now I’m seeing the pistol models are not mil spec and therefore this Handguard may not work. Anyone know about this? Thanks

I will if I buy one and modify it. If it doesn’t work you’ll see a picture of it in the trash lol

Don’t care about the warranty. It’s a piece of plastic. I can always buy another one later. But then if modifying the shell can’t work then I won’t need to buy another one anyway.

Anyone know if it’s possible to modify an XDM shape shift shell to fit the xdm elite models? Can you make a groove for the ambi slide release and cut the top enough for a red dot? For the subcompact guns. Thanks.

Well I already bought an RMR and got it mounted up the other day. I’m good now. Thanks for that info though.