testtest

.308 Winchester stuck cases.

D

Dan Welch

Alpha
Hello folks. Looking for some help. I am new to this forum but have been reloading for years. Mostly handgun ammo.
I am having my .308 Winchester brass getting stuck in my resizing die. Yes I am using lube, tried two different brands, Lyman spray and Lee tube. I have tried three different dies, all three have the same "stuck" problem. I am not experiencing this problem reloading my 30-06 or my .223. Any suggestions?
 
Is this brass fired in a gun you own or was it range brass or purchased once fired?

How did you adjust the sizer die? You may be trying to move the shoulder of the case too far back.

Is there any chance that you have your expander/decapper set too low in the die?
If it is, it will run into the web of the case.

If it was fired in a firearm that had a larger chamber such that the web (base of the cartridge) expanded, you may not be able to resize that part of the case.
 
Is this new brass? Or once/range pickup brass. Show the head stamp and an unsized case. IIRC, brass fired in G3s or other foreign military autos is a bear to reload.
 
As noted, range brass CAN be a problem. If it occurs with YOUR brass that’s a different issue. Are you using sufficient lube? The carbide dies if available should resolve the issue, but I’d look for “why” first…
 
You must log in or register to reply here.
Back
Top