I recently bought the saint victor 5.56 and before any use whatsoever, I noticed the ambidexterous safety selector is loose on the right side (but not the left). Has anyone else found this to be the case? I cannot tighten it with a torx or allen wrench. How to tighten it down some?
saint victor 5.56 ambi safety being loose on right side
- Thread starter eagle1258
- Start date
BangBang
Professional
BangBang
Professional
If you are comfortable, I would do this, follow this guide and start over, make sure everything is right. It’s not hard to do and if my safety wasn’t right, from the factory and being something simple, to work on I’d do this. https://www.windhamweaponry.com/installation-of-an-ambidextrous-safety/
Yes, I tried tightening the screw and it does not tighten any further. I'll take a look at the details and watch a couple videos on how this should be done. I'm not familiar yet with taking apart the detent and springs, but I may give this a try, Thank You.You should be able to tighten it up on the right side?
Last edited:
Keystone19250
SAINT
It’s not difficult, just go slow so you don’t lose the spring.