testtest

What have you bought firearms related in the last 48 hours?

I'm not in a living situation that will allow me to do so, but I expect to rectify that fairly soon... SO, I have ordered some molds and other necessities that will enable me to begin bullet casting once again. I had a set of casting equipment many, many moons ago, but foolishly sold it. I'm looking forward to reliving the experience.
 
from kak
2 magnum bolts
5 hp magnum firing pins

it's fun shooting short mag cartridges from an ar10 platform...........now to decide on what other cartridges........i currently have the 6.5prc & 7saum...........i'm thinking 338rcm, 6.8western & 300saum for over 175's and 300wsm for 175's and under/less due the the case being longer
 
The only loads I've used were imi 250smk's. Felt recoil was mild to my surprise
Gonna try to find my old data book but I do recall shooting a lot of 250's. Sold the rifle, dies and reloading components. It was a lot of fun but expensive to shoot and there were no real long ranges anywhere close to me. Can't remember the custom action but had a McMillin stock, 30" Shilen barrel & Nightforce 5-20(?) scope. Shooting at 100 yards even 200 yards was a waste of ammo and got boring. This was about 25 years ago.
 
Gonna try to find my old data book but I do recall shooting a lot of 250's. Sold the rifle, dies and reloading components. It was a lot of fun but expensive to shoot and there were no real long ranges anywhere close to me. Can't remember the custom action but had a McMillin stock, 30" Shilen barrel & Nightforce 5-20(?) scope. Shooting at 100 yards even 200 yards was a waste of ammo and got boring. This was about 25 years ago.
I ONLY HAVE A FACTORY SAVAGE 110 stealth that has a 24" barrel 9.25 or 9.35 twist. i've only shot out to 200 yards, but since i have enough range on my property i could go out as far as 2 miles. the terrain make it difficult not to mention the cattleand overhead powerlines and roads used by oil & gas companies. the best or longest range for me is the 120 acre center pivot circle that could get me out to 1,000-1,200 yards at a good angle.
 
brownells

3 18 round 357sig/40s/w mags
1777852822837.png

1/2x28 p320 comp
1777852755104.png

aimpoint coa 3.5moa dot
1777852700911.png
 
now i'm pi$$'d at brownells.................i select in stock for my searches and usually get notified if the amount selected is beyond what's in stock............well the mags and comp went to back order status after purchase was made..............time to call them tomorrow and school them
 
I ONLY HAVE A FACTORY SAVAGE 110 stealth that has a 24" barrel 9.25 or 9.35 twist. i've only shot out to 200 yards, but since i have enough range on my property i could go out as far as 2 miles. the terrain make it difficult not to mention the cattleand overhead powerlines and roads used by oil & gas companies. the best or longest range for me is the 120 acre center pivot circle that could get me out to 1,000-1,200 yards at a good angle.
Wow would have loved trying it out at much longer ranges. Have looked high and low can't find my 338 data book. Did find data on 6.5CM pretty extensive with numerous loads chronographed did a lot of testing the for the most accurate bullet, powder, primer combination. Didn't have a super accurate rifle was a Ruger Precision rifle 26" stock barrel best group was 1/2" at 100 yards.
 
Wow would have loved trying it out at much longer ranges. Have looked high and low can't find my 338 data book. Did find data on 6.5CM pretty extensive with numerous loads chronographed did a lot of testing the for the most accurate bullet, powder, primer combination. Didn't have a super accurate rifle was a Ruger Precision rifle 26" stock barrel best group was 1/2" at 100 yards.
what bullets have you loaded for it (creed)
 
what bullets have you loaded for it (creed)
Hornady 129gr Interbond, Hornady 140gr A-Max and my most accurate Berger 140gr Hybrid Target. Tried a few powders settled on H-4350, Norma brass & Fed 210M primers. Powder charge went from 41.5 to 42.3 in 2/10's increments. Most accurate 42.1, 10 round average MV 2788, ES 18 & SD 24. Fire formed case, neck sized, .020 jump.
 
from kak
2 magnum bolts
5 hp magnum firing pins

it's fun shooting short mag cartridges from an ar10 platform...........now to decide on what other cartridges........i currently have the 6.5prc & 7saum...........i'm thinking 338rcm, 6.8western & 300saum for over 175's and 300wsm for 175's and under/less due the the case being longer
Have mercy!! Now they are carving extra meat out of AR10 bolt faces??? Will the madness never cease??
 
Back
Top