Finished the Tx22 FRT chassis build. Arrived today
Needs a new RDS. Actually lacking one and have to purchase. Oh darnFinished the Tx22 FRT chassis build. Arrived today
View attachment 115552
Whatever that is.....Romeo5 gen II for the tx22 frt chassis
A Sig red dot to go on a Taurus 22 with a FRT in that is encased in an sbr like chaccis.Whatever that is....
A Sig red dot to go on a Taurus 22 with a FRT in that is encased in an sbr like chaccis.
But i spelt chassis wrong, the gatekeeper musta been sleeping.
Whatever that is.....
Remember that there are olde parts that speak and write English!![]()
Marlin 45/70, Henry 357 mag and RIA Pak out 12 gauge.
View attachment 115604View attachment 115605View attachment 115606View attachment 115607View attachment 115608View attachment 115609View attachment 115610View attachment 115611
Have you ordered a suppressor for it yet?Well, I'll just say it wasn't @SimonRL 's enabling vibes, although those are working on something else. We were at Runnings in Moorhead looking for some chairs for the "under the deck oasis", and the husband wandered off to the boomstick department. It just so happened that they had a XDM Elite 4.5 threaded barrel in FDE in 9mm. They were clearing out their stock, this was the only one. The husband says, "So, you buying it?" , so he gets the props at being the enabler this time.
View attachment 115676
Of all the springfield handguns that one is my favoriteWell, I'll just say it wasn't @SimonRL 's enabling vibes, although those are working on something else. We were at Runnings in Moorhead looking for some chairs for the "under the deck oasis", and the husband wandered off to the boomstick department. It just so happened that they had a XDM Elite 4.5 threaded barrel in FDE in 9mm. They were clearing out their stock, this was the only one. The husband says, "So, you buying it?" , so he gets the props at being the enabler this time.
View attachment 115676
The bottom 1 is erect as hellFinal: lwrc M6
Added an Aimpoint PRO w Vortex 3x magnifier. Going to share a Dillon DR556 suppressor with another AR.
View attachment 114805
Sitting with its big brother the Six8 6.8 Spc
View attachment 114806
It's about time you posted again.i went and got the Holson SCS-MOS-GR green dot optic, for my G-19 carry.
real quick and simple to install, my new Real Avid torque driver did a fine job of 15 inch pounds to the screws as well.
all i have to do is get to the club monday (tomorrow) morning and make any adjustments needed.
i will be sighting it in for 15 yards, as i have been watching videos from people on you tube, that i trust.
cost at the large LGS was below retail, and frankly Amazon sells it for the same price
I did have to dremel the holster a tiny bit where the optic touches the holster, and the gun still "locks into place"
View attachment 115681
View attachment 115682
the recharging solar panel
View attachment 115683
i had to cut some holster material from where you see the tiny GLOCK stamp, up tp the sight
View attachment 115684
it's a part of yer Arkysawian magination.It's about time you posted again.
Well, I'll just say it wasn't @SimonRL 's enabling vibes, although those are working on something else. We were at Runnings in Moorhead looking for some chairs for the "under the deck oasis", and the husband wandered off to the boomstick department. It just so happened that they had a XDM Elite 4.5 threaded barrel in FDE in 9mm. They were clearing out their stock, this was the only one. The husband says, "So, you buying it?" , so he gets the props at being the enabler this time.
View attachment 115676