Recent content by uspatriot1960

I’m no expert, but I’m not sure what shortening the spring will do for you. Those all look like pretty good hits to me. I’d go out and buy a couple boxes of new ammo and give it a try. I haven’t had any issues with my 911, but then I’m not using decades old ammo with it either.

I haven’t read this thread as I’m not interested in another optic right now, but there are 3 pages of discussion on it. Not sure if it’s good or bad, I just know this optic is discussed here. https://www.ar15.com/forums/Handguns/The-new-Osight-SE/58-216873/

I have one of the Matada loaders. Top notch. You won’t be disappointed.

I have the 911 .380 from new and haven’t had any issues. Mines been very reliable. Like others have said, I’d try a good cleaning and fresh ammo. Don’t give up on it yet, it’s a nice little gun and extremely concealable.

Just as an FYI and take it for what you want. I asked the guys at Otter Creek Labs the following question: “I have a Lithium on a PCC with 6 inch barrel. Do you recommend any type of cleaning schedule? Really the question applies to any center fire can. I’m having a discussion with people about...

I’ve always understood that you don’t really need to clean center fire cans. Rimfire are super dirty and need to be cleaned pretty often, but not so much with center fire. I do clean the 3 lug adapter and lube it. And on my pistol can, I clean the booster. Because these are moving parts and need...

Nice!!

Looks like you’re running a Rugged suppressor on it. 👍🏻 I went with the OCL Lithium and put a 3Lug mount on it. I’m pretty happy with the setup.

The website says this only works with the dual folding adapter. Did you guys use it on the single folding brace that came with the Kuna?

That’s the one I’d get if I got one. I’m not trying to debate, just asking if anyone has an opinion on the legality of having it on a brace. 🤷‍♂️

Try the below. I bought some of the 147 grain and it significantly reduced FRP on my OCL Lithium. I need to get some more. The 165 grain may be even better, but haven’t tried it. I’m going to get some of the .300 BLK ammo as well soon. https://freedommunitions.com/collections/hush

Is the cheek weld for the brace OK NFA wise? Not sure how the ATF would interpret that on a brace…

Seems to me like they made a bad batch of polymer for the mags. If people’s mags were made from that batch, they fail. Mine have been fine and I probably shoot it a two or three times a week for that last 4 or 5 months.

Love mine. Has held strong with no issues. No issues with my mags either. Fun firearm to shoot!!

Since the article states that the case information was gained through a FOIA request, I’d say the chances are pretty good it happened during the past administration…