Optics plate good and tight

[Bear103]

Well got to take the Prodigy out and shoot with the optics plate and optics on. The impact machine plate is good to go. Put 100 rounds of 124 cci through it. So I’d say chasing the threads, cleaning with acetone, then blue loctite and 25 inch pounds on the torque wrench and she’s good to go. Will see as the round count goes up. Also my new operator is sweet as hell.

 

[Jsimon78]

Sounds like a plan. You should be fine with 9MM. If it was 10MM then just watch it.

 

[Bear103]

Sorry been out of the loop for some time between a wedding and work. Plate is still good to go after a couple more hundred rounds. I also watch how I clean the underside of the slide to keep oil from getting in the threads. After I did some “clean up work” with the leaf spring, disconnecter and sear this full size prodigy runs like a top.