testtest

What is your absolute favorite handgun and caliber.

mikep said:
That coyote brown trp… 🤘🏻
Click to expand...
I’m partial to it as well…

IMG_5104.jpeg
 
ECS686 said:
I cut my breath agency wise with S&W DA tevokvers so I always have ran tj very well so a S&W Ruger DA Tevomver is probably my favorite with 38/357 being first and 45 acp in a 625 being up there.

Autos I have ran Sig 220/228 and 226 since 1994 in some capacity so I really like running tjme and I also am quite fond of HK with LEM and am looking at a new VP9 A1 X

Was always a S&W guy and without trying to rant or get off topic i am a little salty at S&W right now got a new Metal (steel frame) M&P that after my first 500 rounds I broke it apart to clean and there is a split in the slide from improper milling. Why I am salty is it went back once my CS rep had zero clue if it was thwre if the status and I got it back with them not apparently reading anything with pictures (i also verbally explained it on the phone)

I sent it back again so we will see. So my next wheelgun might be a Ruger GP 100 WC 3”
Click to expand...
1787441796948.png


I'm only laughing because I have literally gotten the same response from S&W three times for my CSX. Admittedly this was/is for a trigger that randomly freezes up.

I also spoke to customer service at length describing the problem and provided a typed letter just to get it fixed. No sunshine for me. I hope you have better luck.
 
UC_Guy 1971 said:
View attachment 116943

I'm only laughing because I have literally gotten the same response from S&W three times for my CSX. Admittedly this was/is for a trigger that randomly freezes up.

I also spoke to customer service at length describing the problem and provided a typed letter just to get it fixed. No sunshine for me. I hope you have better luck.
Click to expand...


Thanks, what few times in the past I have had great luck and even had free parts mailed to me years past. But lately they have sure nose dived
 
UC_Guy 1971 said:
View attachment 116943

I'm only laughing because I have literally gotten the same response from S&W three times for my CSX. Admittedly this was/is for a trigger that randomly freezes up.

I also spoke to customer service at length describing the problem and provided a typed letter just to get it fixed. No sunshine for me. I hope you have better luck.
Click to expand...
@UC_Guy 1971 i have a Shield Plus that had to go back because the blade safety broke. They replaced it. Now the new trigger locks up if you don’t have your finger placed on it “just right”. I will replace it with an Apex trigger like i did with my other M&P’s.
It is currently back at smith (again) to address a front frame roll pin that “backs out” after 50 rounds and prohibits the takedown lever from functioning.
I’m have several S&W’s but i think i’m done with them.
 
You must log in or register to reply here.
Back
Top