Search results

Anytime….a lot of wisdom and good info on the 1911/2011 platforms here. Members here have guided me and confirmed some of my questions

To me a Magpul mag is a Magpul mag as long as it works

Semi auto 101 So if you look at the follower of your magazine there is a little indent on the side that when the magazine is empty it pushes up on the slide stop after the last round is fired and locks the slide to the rear so you know your empty. When the magazine is loaded the follower is...

I own 3 hammer fired / 1911ish guns. A Kimber Micro 9, a full size Kimber in .45 acp and my 5 inch Prodigy. I have thought about switching from my decked out CR920x to carrying a 1911. But it still gonna have a light and optic if I do. The smaller striker fired guns are lighter to carry when...

Do the guide rods accidentally lock open in the middle of shooting? Would be my luck lol. Also where can I get a replacement front sight like yours?

Can I use the stock reverse plug instead of the keyed but change the guide rod?

That was what I was curious about

Well I was able to get some peace finally, I installed a new Red Dirt Trigger and Magwell. By the way the guy sells these things on eBay for like 20 bucks. It’s a copy of the EGW. Very well done. The pistol passed all function checks and I’ll have to wait until next week to hit the range.

Will keep you guys in prayers if that’s acceptable.

Listening to my monster in law complain

I guess my poor *** could tighten up those flyers 😁

I honestly can’t remember how I came up with it, I figured the trifecta, coffee, nicotine and onryness…

Did you have to shorten any of the optics screws?

So are there issues with the screw length and or thread pitch with the AOS Plate and optic? Specifically Holosun and grinding screws together shorten them. I’m going to go with either the Impact Machine or AOS. So I’m trying to understand more about the AOS plate system as far as the optic to...

Ok so who is running the Agency Plates and did you have to modify any screws for the optics to plate? Trying to decide between the IM and AOS plates…help ! 😁

I was curious what screws the Impact Machine plates come with. Pretty sure I’m going to run a EPS carry. Will I have to alter the screw length any on the optic to plate fit?

I have 2 Microtechs, a OTF Dirac Delta and LUDT Gen 2

Red Dirt Trigger and EGW extended slide stop

So you guys know I’ve been researching optics and plates for my Prodigy. I measure twice and cut once as my papaw used to say. So I think I found the correct 6x48 screws for the plate to slide at ACE hardware as they have a gun screw section. So I have trust issues that are an occupational...